16 HDS4.1 Component Video Switch
Step 1: Reset All Parameters to Factory Defaults
1 2 3 4
ZEKTOR
Start by pressing and
holding the Power
button...
1
2
...while continuing to hold the Power
button, press and hold both the ‘2’
and the ‘3’ buttons.
After about 4 seconds, the display will fl ash
indicating all parameters have been restored
to their factory programmed values.
3
5HDS4.1 Component Video Switch
Step 1...
Use the analog input connections to switch component
video / composite video / analog audio or any combina-
tion of the above signals to the HDS4.1’s analog output
connectors. Use the digital audio connectors to switch
digital audio signals, with full format conversion between
the optical and coax digital audio formats.
Plug the power module into the HDS4.1, and plug the
module into a standard A.C. wall receptacle. The standby
LED will light up.
Step 2...
To switch between any of the four inputs, simply press
the button for the desired input. If the HDS4.1 is in the
standby, it will turn on. The HDS4.1 will then switch to the
selected input, and the associated LED will light to indi-
cate this.
To place the HDS4.1 back into the standby mode, press
and release the Power Toggle button. The channel LEDs
will all go blank, and the standby LED will light up. Press
the Power Toggle button again to re-select the previously
selected input.
Step 3...
Use nearly any remote to control your HDS4.1!
Using any remote to operate the HDS4.1 is a simple mat-
ter of pairing up the HDS4.1 with the remote. The remote
doesn’t have to be a universal remote (although it can be),
any remote from an old TV or VCR will work just fine.
Using Zektor’s exclusive Intelligent-IR, setup is easy! The
HDS4.1 does all the work!
Turn to the next chapter for simple instructions
on how to pair up the HDS4.1 with any remote!
•
•
•
•
•
•
•
Easy, Simple, Instructions!
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji